Thingiverse
OpenScan Tough - Photogrammetry Turntable
door all_scan_everything
293
Downloads
188
Likes
2
Makes
This is a "tougher" version of the brilliant OpenScan 3d Scanner designed to withstand a shared fabrication lab environment. It remains fully compatible with the original electronics and arduino sketch.
Changes include:
608zz bearings at axis of rotation
8mm bolts with nylon locknuts for axle
Removal of all press-fit parts
Brass heat-set inserts for all threading
Reinforcement of printed parts
In addition to the printed parts, you will need the following:
6x: M3 x 0.50 mm Brass Heat Set Inserts Link (McMaster-Carr)
6x: M3 x 0.5mm x 10mm Button Head Screw Link (McMaster-Carr)
2x: M8 x 1.25 mm x 65 mm Hex Head Bolt Link (McMaster-Carr)
2x: M8 x 1.25 mm Nylon Locknut Link (McMaster-Carr)
2x M8 Washer Link (McMaster-Carr)
4x: 608zz Ball Bearings Link (Folger Tech)
You can replace the M8 bolts, locknuts and washers with 5/16" hardware.
Changes include:
608zz bearings at axis of rotation
8mm bolts with nylon locknuts for axle
Removal of all press-fit parts
Brass heat-set inserts for all threading
Reinforcement of printed parts
In addition to the printed parts, you will need the following:
6x: M3 x 0.50 mm Brass Heat Set Inserts Link (McMaster-Carr)
6x: M3 x 0.5mm x 10mm Button Head Screw Link (McMaster-Carr)
2x: M8 x 1.25 mm x 65 mm Hex Head Bolt Link (McMaster-Carr)
2x: M8 x 1.25 mm Nylon Locknut Link (McMaster-Carr)
2x M8 Washer Link (McMaster-Carr)
4x: 608zz Ball Bearings Link (Folger Tech)
You can replace the M8 bolts, locknuts and washers with 5/16" hardware.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
