Thingiverse
Opterra Wing Hatch
von malcolmchurn
17
Downloads
5
Likes
0
Makes
Wing hatch, case & duct for Eflite Opterra 2M, I have included step files to make it easier for remixing.
To mount, attach the case to grill with the screws and place in wing to check it fits well, remove, apply a foam safe glue to the underside of the case and push in to wing, once bonded the screws can be removed to release the hatch leaving the case in the wing.
You will need 4 off 2 x 8mm Cap screws.
To mount, attach the case to grill with the screws and place in wing to check it fits well, remove, apply a foam safe glue to the underside of the case and push in to wing, once bonded the screws can be removed to release the hatch leaving the case in the wing.
You will need 4 off 2 x 8mm Cap screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
