Optic Carry Handle

Optic Carry Handle

Based on the "NcSTAR Gen II Quick Release Carry Handle For Micro Dot"

Print in the orientation of the of the images shown
Add brim to ensure the print stays stuck to the bed.
Supports will need to be turned on.

If print is under extruding, try printing at a slower speed.

This Optic Carry handle raises the Optic just slightly and looks cool. There are no other reasons.

Optic compatibility designed for Holosun redot HS403C
Use the low mount optic not the high mount.

Hardware needed:
2 - M4 x 35mm bolt (Found at lowes or homedepot in packs)
2 - M4 Nut (Found at lowes or homedepot in packs)
Original hardware for mounting the optic.

Check out my other designs:
- CP33 Suppressor Shroud V1.0
- OCP33 Suppressor Shroud V2.0 (much improved over V1.0)
- Digitalnimbuslabs Cp33 Brace remix (Coming Soon)
- Cp33 Forward chargin handle (it probably wont be 3d printed, coming soon)
- Bullpup Pellet gun stock conversion??? (it wont fit your pellet gun)