Optimum's FormD T1 Bracket (Inspired)

Underside Desk Brackets for the FormD T1 featuring 10mm - 30mm clearances with or without screw holes to secure your precious FormD T1 into place. This is a remixed design offering lower clearance heights between the T1 and the top underside of the bracket/desk.Highly recommend printing in PETG/ABS at an infill of 40% or higher for maximum strength to combat the affect of moisture in the long term.To be printed flat on its left or right hand side for better tension under load.2 main Screw Holes are designed for (Imperial) #10 x 1 ¾" / 5.0 x 45mm (Metric) screws with length dependent on overall desk thickness. The Screw needs to drive in at a minimum of 20-25mm so make sure your desk is a minimum of 25-30mm in thickness for the screw to properly bite and hold into the wood. The 3rd screwhole underneath the gap in the bracket is for stabilisation purposes to prevent potential bowing. It requires a (Imperial) #10 x 3" / 5.0 x 75mm (Metric) screw.For the general version of the brac