Slicer Discord
Optiplex 3020 Lack Mounting Bracket – 3D-Druckmodell von Thingiverse Thingiverse

Optiplex 3020 Lack Mounting Bracket

von RTWinter
3 Downloads
3 Likes
0 Makes
Zum Modell
Mounting bracket to attach a Dell Optiplex 3020M SFF PC to an Ikea Lack table or similar. May fit other Optiplex SFF PC's but I have not tested.

Front bracket attaches with 2x #6 wood screws to leg and the underside of the table.
Rear bracket attaches with 2x #6 wood screws to underside of table.

PC slides in from front, and is stopped by the rear bracket. The stops at the back do not interfere with any IO on my 3020 but your milage may vary if you are using this with another PC.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Wood PLA, Polycarbonate
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen