Thingiverse
Optoma Projector Ceiling Mount Bracket
von DocDrill
1
Downloads
1
Likes
0
Makes
I designed this because I didn't like the 1-Size-Fits-All adjustable bracket that the ceiling mount came with. It's combersome to attach, super clunky, and obnoxiously big.
I designed it so that the channel crosses the center of gravity. That way, you can slide it till you get it properly centerered, tilt-wise. Also, it can be printed flat without supports or on edge. Either way, it'll be difficult to have zero issues, but should be sufficient for function. I HATE supports, particularly in tight areas. So, I'll take the slight delamination at the bevel to avoid removing supports. There are ways to avoid this, but for now, i'm proceeding as is.
Optoma H184X Projector: https://amzn.to/3jpfjzr
Ceiling Mount: https://amzn.to/2YJEg0K
80" Portable Screen: https://amzn.to/3jmrUDt
I designed it so that the channel crosses the center of gravity. That way, you can slide it till you get it properly centerered, tilt-wise. Also, it can be printed flat without supports or on edge. Either way, it'll be difficult to have zero issues, but should be sufficient for function. I HATE supports, particularly in tight areas. So, I'll take the slight delamination at the bevel to avoid removing supports. There are ways to avoid this, but for now, i'm proceeding as is.
Optoma H184X Projector: https://amzn.to/3jpfjzr
Ceiling Mount: https://amzn.to/2YJEg0K
80" Portable Screen: https://amzn.to/3jmrUDt
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!