Thingiverse
Orange Pi 3
door Fat_Zer
7
Downloads
4
Likes
0
Makes
A model of Orange PI 3.
The model is very rough. It's primary intended to be used to design a case for the board.
There is not much info available on the physical dimensions of the board. Dimensions of the bored and hole placements should be accurate, but placement of the components isn't that much. All of those have been measured manually. The expected allowances are about ±0.2mm.
The model is very rough. It's primary intended to be used to design a case for the board.
There is not much info available on the physical dimensions of the board. Dimensions of the bored and hole placements should be accurate, but placement of the components isn't that much. All of those have been measured manually. The expected allowances are about ±0.2mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
