Thingiverse
Orange Pi Lite - Case
door MazeMieter
35
Downloads
29
Likes
2
Makes
A case for Orange Pi Lite, I use it for OctoPrint.
It has a hole at the top that is tight enough to hold the antenna in place. It is a tight fit, no need for screws. And as you can see from the images the camera interface, GPIO pins, IR receiver and reset button are not usable.
You might want to add four legs at the bottom to allow air to flow in, if you do a lot of RAM access, at least for OctoPrint this is not necessary.
It has a hole at the top that is tight enough to hold the antenna in place. It is a tight fit, no need for screws. And as you can see from the images the camera interface, GPIO pins, IR receiver and reset button are not usable.
You might want to add four legs at the bottom to allow air to flow in, if you do a lot of RAM access, at least for OctoPrint this is not necessary.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
