Orange Pi Plus Cluster Case

This is a stackable case for the Orange Pi Plus in a cluster configuration. The Orange Pi Plus fits inside and the cases can be stacked on top of each other in a cluster configuration.

Suggested configuration is a maximum of 4 Orange Pi Plus on top of each other. Including the top, a total of 5 prints are required for this configuration.

If you like, you can put the first case on the pins...
The top is to cover the last case.

The 3 xml-files are BlocksCAD-generated.

And yes: I know about modules even before ver5... ;-). It was a "quicky".
Pls see ver5 and/or xml if you like modules.

Ver6 is out now :-).
Seperate files for pins and top. Adjust a couple of millimeters on the pins for the board.