MakerWorld
Electronics
Model downloaden
Orange Pi Zero 3 Case
51
Downloads
7
Likes
0
Makes
his is a slim case that requires no screws for assembly. In fact, the clips on my printed version were so tight that I believe they are 'forever'.Added some vents for heat, and I routed my antenna cable between the RJ-45 and USB ports. Wouldn't be difficult to disconnect the antenna and push it through a vent if desired.Printing requires no supports, just place the flat side of each half on the print bed. To assembly, carefully guide the 4 clips to their slots.Update 08-23-2023 - added a version of the case top with a 16x16mm heatsink opening
Gerber publiceert ook op
34 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!