Thingiverse
Electronics
Ver Modelo
Orange Pi Zero 3 Snap Case
52
Descargas
101
Likes
3
Makes
This is a slim case that requires no screws for assembly. In fact, the clips on my printed version were so tight that I believe they are 'forever'.
Added some vents for heat, and I routed my antenna cable between the RJ-45 and USB ports. Wouldn't be difficult to disconnect the antenna and push it through a vent if desired.
Printing requires no supports, just place the flat side of each half on the print bed. To assemble, carefully guide the 4 clips to their slots.
**Update 08-23-2023** - added a version of the case top with a 16x16mm heatsink opening
Added some vents for heat, and I routed my antenna cable between the RJ-45 and USB ports. Wouldn't be difficult to disconnect the antenna and push it through a vent if desired.
Printing requires no supports, just place the flat side of each half on the print bed. To assemble, carefully guide the 4 clips to their slots.
**Update 08-23-2023** - added a version of the case top with a 16x16mm heatsink opening
sclebo05 también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
