Thingiverse
Orange Terror Stamp Logo
von BrandT90
1
Downloads
0
Likes
0
Makes
Orange Terror Stamp pedal logo. I wanted some logos to put on my table that my cab sits on so I made this.
I set a pause in my gcode so I could switch filament for the raised logo. Just scale to your preferred size/height, preview and set the pause at the desired height.
Unfortunately, I forgot to reduce the temp and flow for the first layer of black so I had to do a bit of cleanup with an xacto knife and the "AMP" part is a little overextruded.
I set a pause in my gcode so I could switch filament for the raised logo. Just scale to your preferred size/height, preview and set the pause at the desired height.
Unfortunately, I forgot to reduce the temp and flow for the first layer of black so I had to do a bit of cleanup with an xacto knife and the "AMP" part is a little overextruded.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!