Thingiverse
OrangePi Zero 2 cooling solution
door fiveoga
1
Downloads
2
Likes
0
Makes
This is a cooling kit which can be printed using PETG, ABS or PLA materials and used on the OrangePi Zero 2. The kit can be installed on the pedestal of printer , and it's easy to disassemble.
A small 20X20X 5V fan, that is to say the cooling kit lies on top of the chip pasted by a metal cooling fin.The fan can be powered from the 26-pin expansion port.
The bracket that holds the circuit board needs to be fixed with M3X8 screws.
The whole bracket needs to be fastened with 3mm hot melt nuts and M3X8.
Have lots of fun.
A small 20X20X 5V fan, that is to say the cooling kit lies on top of the chip pasted by a metal cooling fin.The fan can be powered from the 26-pin expansion port.
The bracket that holds the circuit board needs to be fixed with M3X8 screws.
The whole bracket needs to be fastened with 3mm hot melt nuts and M3X8.
Have lots of fun.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!