Slicer Discord
Orb Box – 3D-printbaar model van MakerWorld MakerWorld
Decor

Orb Box

door LoboCNC · Decor
130 Downloads
77 Likes
72 Makes
Model downloaden
This simple sphere transforms as the flush lid lifts and then rotates out of the way as you turn the dial on the bottom. PrintingThis prints pretty easily in PLA. I used 0.2mm layers, but for the lid, I used a variable layer height to smooth out the steps at the top of the sphere. The lid also needs paint-in supports on just the surface indicated. Remove these supports after printing. Assembly1. Do not insert the stem of the dial into the box body yet! It is a little tricky to disassembly.2. Test screw the stem of the dial into the hole in the post on the lid. Note that it is a left-handed thread. Work the thread back & forth, wearing away any nits and goobers, until the two operate smoothly. You can add a little lubricant to the thread if you like. Make sure that the lid can screw all the way down until it seats against a hard stop.3. Now insert the stem of the dial into the bottom of the base. It will click into place with the small clip shown below. Press the dial against the bottom
Categorie
Decor
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
0.20mm lagen · uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 3/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Laaghoogte
0.2 mm
Nabewerking
Schilderen, Schuren, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

LoboCNC publiceert ook op

313 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie