Thingiverse
Orbiter flip
von yd007
9
Downloads
6
Likes
0
Makes
Changed the orientation of the orbiter Extruder to be over the ender rail.
I would assume it's gives a better gravity center position, and a different look to the head.
This has been done, by modifying the step files provided, mostly moving the screws
and rotating top parts.
It works well with orbiter 1.5 and LDO motors LDO-36STH20-1004AHG(XH), but the gap leave between the ender 3 struture is quite small: 1/2 mm. A wider motor won't fit the rail.
Remixed step files integrated into [derivative github repos](https://github.com/yduf/Tiki3).
Everything else is the same and can be gathered from original design.
This remix cannot use the original cable relief, but I am considering remixing something like [this one](https://www.thingiverse.com/thing:4974602) to replace it.
** Update model shot** 22/07/2022
Take better looking shot of the model, as I improve my freecad knowledge. Parts are unchanged.
I would assume it's gives a better gravity center position, and a different look to the head.
This has been done, by modifying the step files provided, mostly moving the screws
and rotating top parts.
It works well with orbiter 1.5 and LDO motors LDO-36STH20-1004AHG(XH), but the gap leave between the ender 3 struture is quite small: 1/2 mm. A wider motor won't fit the rail.
Remixed step files integrated into [derivative github repos](https://github.com/yduf/Tiki3).
Everything else is the same and can be gathered from original design.
This remix cannot use the original cable relief, but I am considering remixing something like [this one](https://www.thingiverse.com/thing:4974602) to replace it.
** Update model shot** 22/07/2022
Take better looking shot of the model, as I improve my freecad knowledge. Parts are unchanged.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
