Orc

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Size 150x200mm. Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. You may print at higher layer heights below the Min Depth of 0.56mm. The Max Depth is 2.1mm and the Actual Depth is 2.1mm   It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.   These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. Filaments Used:     PLA Elegoo+ Black Transmission Distance: 0.3     PLA Devil Design Navy Blue Transmission Distance: 1.6     PLA Sunlu META Grey Transmission Distance: 3.6     PLA BambuLab Basic Orange Transmission Distance: 4.8     PLA BambuLab Matte Ice Blue Transmission Distance: 2.8     PLA Elegoo + White Transmission Distance: 7 This print uses 6 unique filaments   Swap Instructions:     Start with Black     At layer #10 (0.88mm) swap to Navy Blue     At layer #11 (0.96mm) swap to Grey     At layer #13 (1.12mm) swap to Orange     At layer #14 (1.2mm) swap to Ice Blue     At layer #15 (1.28mm) swap to White for the rest.