Orcrist - The Hobbit

THIS IS A DEMO VERSION, YOU CAN FIND THE FULL VERSION AT
https://www.aguilarworkshop.com/product-page/orcrist
OR READ MORE ABOUT IT HERE
https://www.aguilarworkshop.com/post/orcrist-the-hobbit

Major Features

(Mostly) Seamless Inset Design

With the exception of the blade, which was required to be split in two to fit most printers, all of the pieces of this sword fit together in such a way that there are no visible seams. Both the blade and hilt fit into the hand guard, while the pommel slips over the end of the dragon tooth hilt.



Two Part Blade w/ Built in Alignment Peg

As can be seen above, the blade was split in two. An alignment diamond was included to make fitting the two pieces together a much easier task.



Cirth Runes

I had to actually look up the Cirth alphabet to try and match up the runes to what I could see on the sword, and hand model the runes into the filagree