Thingiverse
Origami-Inspired Crane
von LedHead56
124
Downloads
120
Likes
1
Makes
Designed on a traditional origami crane. Fusion 360.
Printing:
Standard printing procedure. Support material is needed for the head of the crane.
I used:
– 0.2mm layer height
– 10 line count brim
– 20% cubic infill
– 3 top and bottom layers
– Normal support structure
– Support placement: Everywhere
There may be stringing around the wings, tail and head.
Printing:
Standard printing procedure. Support material is needed for the head of the crane.
I used:
– 0.2mm layer height
– 10 line count brim
– 20% cubic infill
– 3 top and bottom layers
– Normal support structure
– Support placement: Everywhere
There may be stringing around the wings, tail and head.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!