Thingiverse
Learning
Go to Model
Orion
36
Downloads
28
Likes
0
Makes
Designed this Orion constellation to print in glow filament for kids' bedrooms.
Printing:
I printed at 75% size, .2 mm layers, and 100% infill. Printing at 33% size had some issues because the lines were too thin to easily remove from the buildplate. There was a minor issue where the line connecting the head stars to Betelgeuse didn't meet 100% that should be fixed in this STL that was there in the prints I did.
Printing:
I printed at 75% size, .2 mm layers, and 100% infill. Printing at 33% size had some issues because the lines were too thin to easily remove from the buildplate. There was a minor issue where the line connecting the head stars to Betelgeuse didn't meet 100% that should be fixed in this STL that was there in the prints I did.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
