Ormerod BLTouch Mount

This is a mount to allow a BLTouch to be used with an Ormerod printer.

This object requires the Ormerod 2 E3D v^ Hotend Mount with Fan mount to be installed (https://www.thingiverse.com/thing:1005956).

This object uses the fan mounting bracket on the mount to attach to the printer, and when installed with an M3x15 screw is rigidly attached to the print head.

Wiring the BLTouch to the Duet 0.6 controller on the Ormerod is as follows:

Red wire to Pin 1 on the expansion header
Brown wire to Pin 2 on the expansion header
Orange wire to Pin 31 on the expansion header.

Black and White need to be connected to "GND" and "IN" on the E0 endstop connector - they will not work anywhere else.

GCode is:

In config.g

M307 H3 A-1 C-1 D-1 ; Release the heater pin to be used to control the BLTouch servo
M558 P4 X0 Y0 Z1 H5 F100 T2000 ; set the Z-proble to mode 4
M574 Z1 S1 '; set the Z stop to Active High
M557 X10:140 Y10:180 S20 ; Set up bed mesh levelling to probe betwe