Thingiverse
Ormerod Y-Axis bed leveling adjustment
door fotomas
26
Downloads
17
Likes
2
Makes
A modified version of the Ormerod 2 Y-idler bracket. Assists in fine adjustment of the twist of Y-axis bars.
If you calibrate your bed so that the X 0 side of the bed i level then the X 200 side of the bed should also be level. If not your Y-axis bars are probably twisted. Adjusting this can a bit tricky and this part helps getting the values within 1/100 of a mm.
Remember to loosen the screws holding black during adjustment and tighten them you are done.
The bracket is also reinforced in the back, to avoid cracks. It overshoots the aluminium profile by 5 mm.
Attached is also a remix of a bracket made by user jsv555 at the reprap forum. It as ha spring loaded lever for belt tension.
If you calibrate your bed so that the X 0 side of the bed i level then the X 200 side of the bed should also be level. If not your Y-axis bars are probably twisted. Adjusting this can a bit tricky and this part helps getting the values within 1/100 of a mm.
Remember to loosen the screws holding black during adjustment and tighten them you are done.
The bracket is also reinforced in the back, to avoid cracks. It overshoots the aluminium profile by 5 mm.
Attached is also a remix of a bracket made by user jsv555 at the reprap forum. It as ha spring loaded lever for belt tension.
fotomas publiceert ook op
9 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
