Thingiverse
Ornament Hook
von Walpolea
120
Downloads
89
Likes
0
Makes
This is a simple ornament hook I put together to go with some custom 3D printed ornaments.
At it's thickest, the hook prints about 3mm thick, so you want a hole with at least 3mm diameter for it to fit. I used 5mm diameter holes and they were perfect for maximum dangle-factor.
For best and quickest printing, increase your walls to 4 so the entire hook is made of walls rather than any infill.
At it's thickest, the hook prints about 3mm thick, so you want a hole with at least 3mm diameter for it to fit. I used 5mm diameter holes and they were perfect for maximum dangle-factor.
For best and quickest printing, increase your walls to 4 so the entire hook is made of walls rather than any infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
