MakerWorld
Hueforge & Lithophane
Zum Modell
OrnamentalOwl
14
Downloads
15
Likes
5
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. X and Y can be adjusted but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 2.5PLA BambuLab Basic Gray Transmission Distance: 3PLA BambuLab Basic White Transmission Distance: 6This print uses 4 unique filaments. Substitue as you see fit. Swap Instructions:Start with BlackAt layer #10 (0.88mm) swap to GrayAt layer #14 (1.2mm) swap to GrayAt layer #21 (1.76mm) swap to White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!
Corp veröffentlicht auch auf
338 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
