Orqa FPV One goggle strap retainer

This is the Orqa FPV one goggle strap annoyance preventer clip. I found the straps constantly pull out and fall off, especially when using the Orqa battery. So I made this, it's a little tricky to put in, easy on the left side, but tricky on the battery side.

You want to have the strap on first, stretch it out and insert the clip till the retainer ear falls into the center of the clip, make sure the bevel side is down as it is needed to slide over the plastic loop after, once you get it in place, even PLA will flex enough to snap over the plastic and into the final position. Then you have to fiddle with the strap a bit to get it unbunched because it will get bunched underneath the clip. But once it's in place, no more problems with pulling your strap through and off.

I used plain old cheap PLA, it worked fine, a tougher but rigid material would be better. Use whatever you like. I printed with supports for the little ears.