ORTF Clip

I created a microphone clamp for the ORTF-Standard for Neumann KM184.
I designed also clips for other diameters of mikrophones.
The internal diameter of the clip is 0.5mm smaler than the nominal diameter (19-23mm)

Microphone angle: 110 degree
Microphone distance: 170mm (17cm)

To get the right distance, you shoud clamp it 60mm out.

!!! The thread inside must be re-cut with UNC 3/8-16 !!!

Wich diameter should you use?

ORTF_3.5_19mm: e.g. Beyerdynamic MCE530
ORTF_3.5_20mm: e.g. Rode NT5, Shoeps MK4
ORTF_3.5_21mm: ?
ORTF_3.5_22mm: e.g. Neumann KM184
ORTF_3.5_23mm: e.g. SE Elektronics SE8

Print-orientation: Lay the flat side on the print-bed and then print without any support

!!!! UPDATE !!!!
No support from my side. I am not active on thingiverse and do not answer your request.