Thingiverse
OSFA- Spool "Holdller"
door Athruz
16
Downloads
12
Likes
0
Makes
Okay so I took the design and remixed it a bit to make the One Size Fits All- (OSFA) spool "Holdller". Holdller is of course a combination of holder and roller!
I remixed it to make use of some typical spinner bearings, I used some ceramic bearings I had and honestly it almost spins to well. It like zero friction, silky smooth- (enter that's what she said jokes now).
Rods were pieces of 8mm linear shaft, or you can use a steel rod home depot sells that is non-metric but works just as well- 5/16" smooth rod.
http://www.homedepot.com/p/Everbilt-5-16-in-x-48-in-Plain-Steel-Round-Rod-801607/204273948
I remixed it to make use of some typical spinner bearings, I used some ceramic bearings I had and honestly it almost spins to well. It like zero friction, silky smooth- (enter that's what she said jokes now).
Rods were pieces of 8mm linear shaft, or you can use a steel rod home depot sells that is non-metric but works just as well- 5/16" smooth rod.
http://www.homedepot.com/p/Everbilt-5-16-in-x-48-in-Plain-Steel-Round-Rod-801607/204273948
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
