Otter Pole Rod Mount

This is a rod mount for the Otter support poles, found in their X-over (not sure if all models have the same poles). It mounts to the thinner part of the rods, if you measure it, it should be around 20-21mm square-ish. There are 3 variants included, if you mount on a pole straight up, you have the left and right side options, if you mount it on a 45 degree pole, it will already have a lean, so thats the “straight” version, and it should fit on either side. The opening is quite generous, about 40mm, so should fit most rods. I recommend PETG for printing, with good infill and walls for strength. I can't guarantee a 10kg pike wont rip your tent down though, don't blame me for that. If you find that it slides on the pole, take a rubber o-ring and it shouldn't slip. Enjoy the print, and any pic with this rod holder + fish is double appreciated! And if you find it useful, give me BOOST! Helps a ton to save on plastics when I prototype these.