Slicer Discord
OTTO meets SMARS – 3D-Druckmodell von Thingiverse Thingiverse

OTTO meets SMARS

von s4snow
479 Downloads
416 Likes
0 Makes
Zum Modell
Otto needed some new faster way of getting around and borrowed some tracks from SMARS..
He now prefers these to walking..


PARTS:
1 x MAX7219 LED Matrix : https://www.amazon.co.uk/dp/B017CWSKSM/ref=cm_sw_r_cp_ep_dp_bBTPAbBVHR9GN

2 x GA12-N20 6volt dc 150rpm Minature motors : https://www.amazon.co.uk/dp/B017CWSKSM/ref=cm_sw_r_cp_ep_dp_bBTPAbBVHR9GN

1 x HCSR04 Ultrasonic range-finder module :https://www.amazon.co.uk/dp/B017CWSKSM/ref=cm_sw_r_cp_ep_dp_bBTPAbBVHR9GN

1 x Noise sensor module (analog output) : https://www.amazon.co.uk/dp/B017CWSKSM/ref=cm_sw_r_cp_ep_dp_bBTPAbBVHR9GN

1 x BUNDLE of Female to Female jumper wires : https://www.amazon.co.uk/dp/B017CWSKSM/ref=cm_sw_r_cp_ep_dp_bBTPAbBVHR9GN

1 x Active Buzzer (not passive) : https://www.amazon.co.uk/dp/B017CWSKSM/ref=cm_sw_r_cp_ep_dp_bBTPAbBVHR9GN

1 x HC-06 Bluetooth module : https://www.amazon.co.uk/dp/B017CWSKSM/ref=cm_sw_r_cp_ep_dp_bBTPAbBVHR9GN

THESE PARTS CAN BE FOUND ELESWHERE ON THE INTERNET AN
Quelle
Thingiverse
Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz
Supports 1/3
Zusammenbau 2/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
TPU
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen