Ouroboros Snake Extruder Indicator

# Extruder indicator for Prusa MK3S

### Snek try to eat tail but never can do reach.

2 pieces: main body and 0.5 mm standoff.

Add a filament change at the first layer of the snake (starts at 2mm height). You can print the main body and spacer at the same time, but put them close to each other on the bed to minimize stringing between parts. The spacer is 1 mm high so the filament change will not affect it.

- Requires 8x3mm magnet
- Glue the standoff into the divot on the back side, and glue the magnet to the standoff (make sure its centered)
- You may need to print the spacer at less than 100% x/y scale to get it to fit (or just do a tiny bit of sanding around the edges of the spacer)