Thingiverse
Outlet line support - remix
49
Downloads
45
Likes
1
Makes
Simple no support remix for https://www.thingiverse.com/thing:5848751
Update: 05-03-2023
Added a new remix.
The tolerance of these pieces is 0.2mm.
I decreased the angle from 45 to 30 degrees for easier print.
Removed the "lock" on the bottom piece to be able to slide in the outlet from any side.
Added a 0.2mm hole fill for the top piece for easier 1st layer print.
Print the bottom piece (Bottom V1.2.stl) as it is and then you can use the top test piece (Top V1.2 test piece.stl) to check how is sliding. If its too loose or too tight, increase or decrease Y by steps of 0.1 mm. After you find the best fit print the main piece (Top V1.2.stl) with same Y scaling
Update: 05-03-2023
Added a new remix.
The tolerance of these pieces is 0.2mm.
I decreased the angle from 45 to 30 degrees for easier print.
Removed the "lock" on the bottom piece to be able to slide in the outlet from any side.
Added a 0.2mm hole fill for the top piece for easier 1st layer print.
Print the bottom piece (Bottom V1.2.stl) as it is and then you can use the top test piece (Top V1.2 test piece.stl) to check how is sliding. If its too loose or too tight, increase or decrease Y by steps of 0.1 mm. After you find the best fit print the main piece (Top V1.2.stl) with same Y scaling
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
