Thingiverse
Over Complicated Headphone Holder
von IgorTironi
45
Downloads
63
Likes
0
Makes
Designed as a learning piece, and cause I was needing a headphone Holder. The design is extremely overcomplicated on purpose, to challenge my design skills.
You will need to reorient the pieces before print.
The two longer pins go on the top, end the tree shorter ones go on the bottom piece. You will need to use some super glue to fix the caps in place pins. The screw part is advised to go at the bottom piece, but you can change it if you feel like it.
The rest of the build is straightforward.
After printing it, test the screw and nut a little to loosen up.
You will need to reorient the pieces before print.
The two longer pins go on the top, end the tree shorter ones go on the bottom piece. You will need to use some super glue to fix the caps in place pins. The screw part is advised to go at the bottom piece, but you can change it if you feel like it.
The rest of the build is straightforward.
After printing it, test the screw and nut a little to loosen up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!