Thingiverse
Over Engineered Spool Holder
por MunkeyNutz
7
Descargas
4
Likes
0
Makes
Parts
2x 6mm Threaded rod - about 150mm
1x 8mm Threaded rod / bolt + nut - about 150mm
8x 6mm nuts
4x 6mm Acorn nuts - optional but fancy
8x 6mm Washers
2x 22mm Bearings
2x 3d Parts
I may have spent too much time on this, but it works really well.
It was designed to make changing the spool as quick as possible, the whole top part of the holder is removable and it only needs 1 nut to be undone.
The size is adjustable to fit any spool by printing the spacers at different heights depending to the width of the roll. Most rolls fit the default size.
2x 6mm Threaded rod - about 150mm
1x 8mm Threaded rod / bolt + nut - about 150mm
8x 6mm nuts
4x 6mm Acorn nuts - optional but fancy
8x 6mm Washers
2x 22mm Bearings
2x 3d Parts
I may have spent too much time on this, but it works really well.
It was designed to make changing the spool as quick as possible, the whole top part of the holder is removable and it only needs 1 nut to be undone.
The size is adjustable to fit any spool by printing the spacers at different heights depending to the width of the roll. Most rolls fit the default size.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!