Thingiverse
Over Engineered Tool Caddy FlashForge Creator Pro 2016
von ozfoggy
4
Downloads
2
Likes
0
Makes
An over engineered tool caddy for a FlashForge Creator Pro post 2016 with the all in one molded side panel.
All the caddy's I tried were weakly supported and would move/flex/break fairly quickly, so, I over engineered this one. You'll need to replace the 10mm OEM M4 buttonhead capscrew with an M4 washer and 15-16mm screw.
I printed it at 50% infill to try and maintain the strength at its weakest point, fixture attachment neck. The loops that mimic the recess of the molded handle provide some torsional stability.
All the caddy's I tried were weakly supported and would move/flex/break fairly quickly, so, I over engineered this one. You'll need to replace the 10mm OEM M4 buttonhead capscrew with an M4 washer and 15-16mm screw.
I printed it at 50% infill to try and maintain the strength at its weakest point, fixture attachment neck. The loops that mimic the recess of the molded handle provide some torsional stability.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
