Thingiverse
Overhang angle test
von Techniktoni
4
Downloads
1
Likes
1
Makes
The test is a overhang test. I used PLA-tec from http://two-bears.eu/
I have made printed it without any Support material.
The test starts in a angle of 45° and goes up to 75° in 5° steps.
There is no must to do it with Pla.
Disscussion about it at :
https://www.facebook.com/photo.php?fbid=1352105028185749&set=pcb.1290047124415507&type=3&theater
I have made printed it without any Support material.
The test starts in a angle of 45° and goes up to 75° in 5° steps.
There is no must to do it with Pla.
Disscussion about it at :
https://www.facebook.com/photo.php?fbid=1352105028185749&set=pcb.1290047124415507&type=3&theater
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
