Thingiverse
overhead spool holder
door wampablo
3
Downloads
11
Likes
0
Makes
built for 8mm threaded bar.
I was starting to lack space on my desk and came up with this.
The nut holder will need the nut to be pressed in its a little tight but does work well
as I've stated this is a work in progress and I will be making improvements to this as I find problems. one problem I've found is one holder isn't enough to hold the spool level so I've now included a mirrored version for the other side this will enable a longer bar .
I will also be including some modifications to the spool cones by adding bearings.
I was starting to lack space on my desk and came up with this.
The nut holder will need the nut to be pressed in its a little tight but does work well
as I've stated this is a work in progress and I will be making improvements to this as I find problems. one problem I've found is one holder isn't enough to hold the spool level so I've now included a mirrored version for the other side this will enable a longer bar .
I will also be including some modifications to the spool cones by adding bearings.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!