Thingiverse
OverKill/DGJBD 8S 100A BMS Case
por nate_syd
13
Descargas
5
Likes
0
Makes
Designed for the Overkill DGJBD 8S 100A BMS module for LiFePO4 battery packs.
Its a 2 piece housing that contains the BMS with ventilation, the case is around 2-3mm from the heat spreader to make sure of airflow & the case doesnt deform.
Print with ABS/ASA due to the potential of high temperatures.
Dont worry about supports with the air vents it prints fine and if it sags a little - it makes no difference.
4 screws on each corner of the lid will hold it together & 4 screws will hold the case to your chosen surface.
Its a 2 piece housing that contains the BMS with ventilation, the case is around 2-3mm from the heat spreader to make sure of airflow & the case doesnt deform.
Print with ABS/ASA due to the potential of high temperatures.
Dont worry about supports with the air vents it prints fine and if it sags a little - it makes no difference.
4 screws on each corner of the lid will hold it together & 4 screws will hold the case to your chosen surface.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
