Overkill Mecha Murder Mitten

Want your own fleshy appendages replaced with mecha murder mittens?
We're not there just yet, but here's the next best thing :D
designed to fit over a thin mens L sized glove

Each hand requires-
1x T1
3x T2
1x T3
3xM1
1x M2
2x K1
2x K2
1x K3
5x claw tip
5x energy cell
5x cell top
5x cell bottom
1x enclosure box
1x enclosure lid
1x wrist brace

you can either use the plain lid, or fancy inlayed lid.

Designed for my printers tolerance of 0.3mm

Print the wrist brace at 100% infill and use a heat gun to mold it around your wrist (carefully, is hot)
sew some 30mm elastic strap to one end of the brace, then weave it through the other end (with 2 slots) Lets you adjust the tightness to put it on and off.

Run a length of 8mm elastic strap through the fingers, enclosure box , and through the wrist brace.
Adjust the tension once its one and it should be set.

Holes and stuff in place if you wanna light them up, I used 3535 ws2812b led circuits and slapped an ar