Oversized EQ6-R Pro Knobs with retention plates

Pretty simple addition of retention plates to the original design. These knobs are great, making the EQ6R-Pro more precise to polar align and giving you much better purchase when tightening down the saddle.

These knobs fit directly over the originals, leaving your mount in factory condition for possible future resale. Note that you'll need to print two of the retention plates for every knob you print.

To make this work, here is the additional hardware I used:

M4 Brass Inserts x 4 ([here are the ones I used](https://www.amazon.com/dp/B08T9TXS9S))
M4 x 10mm Screws x 4

You can install the two retention plates with one screw each into the two closest holes, making it easy to swing them into place once placed over the original knobs.

I have also included here a version as a direct replacement for the altitude bolt on the south side of the mount. It is a bit of a tight fit, but I was able to get it onto the bolt without too much trouble. No retention plate needed for this one