Overwatch - ORISA

WARNING!!!
This is NOT an optimized mesh for printing. It will take a long time to print! Expect many printing errors, the photo seen here took 12 hours to print and is my third attempt. Expect some areas to be either missing or break off. Expect to hand finish this model with filler.
I sliced this model into parts to make printing easier. There are no locating tabs or sockets. Her top sits on the legs and can be glued as is. The arms are ball and socket and will require significant glue or epoxy to bond.
This is a low poly model expect edges at more than 150% print size.



Use supports, everywhere, grid, 20% .01 or better layer height, 25% or more infill to prevent holes or bad spots but will double or even triple print time.