Thingiverse
Owl eyeglasses holder (solid)
door Zaytas
410
Downloads
305
Likes
4
Makes
Thanks FNT for creating the original! When I went to print it, there is a hole in the model at the base of the cone and was not generating supports properly due to this. I used Meshmixer to make it solid.
I printed mine at 50%. I think 100% is way too big but if I were to print it again I would probably go 60%. Printed mine at .2 layer height.
I printed mine at 50%. I think 100% is way too big but if I were to print it again I would probably go 60%. Printed mine at .2 layer height.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
