Thingiverse
OXO tong handle
por peter120
0
Descargas
0
Likes
0
Makes
The original OXO tong handle has a rubber surface coating that became a sticky mess.
This was printed in carbon fiber PC at 250C on a 150C bed with 0.1mm layer height. The original part used a stainless rivet that needs to be cut and is replaced by a 4-40 stainless bolt in the printed part.
Designed in Fusion 360
This was printed in carbon fiber PC at 250C on a 150C bed with 0.1mm layer height. The original part used a stainless rivet that needs to be cut and is replaced by a 4-40 stainless bolt in the printed part.
Designed in Fusion 360
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!