Thingiverse
Oxy 4 Helicopter Stand
von mattwach
1
Downloads
0
Likes
0
Makes
This stand will keep your Oxy 4 heli from rolling onto its side while driving. It can also be used as a wall hanging stand.
10-12mm M3 bolts are needed to attach the holding tabs.
Printing with PLA is OK but be mindful of leaving the stand in a hot car if you choose a low-melting-point plastic. I don't like leaving my Oxy 4 in a hot car anyway so PLA works for me.
Designed with OpenSCAD.
10-12mm M3 bolts are needed to attach the holding tabs.
Printing with PLA is OK but be mindful of leaving the stand in a hot car if you choose a low-melting-point plastic. I don't like leaving my Oxy 4 in a hot car anyway so PLA works for me.
Designed with OpenSCAD.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!