P1P LED Light w/Cable Management

This is 3D Sourcerer's USB Cable Management Plate edited with a cut out to add the bright LED from those free Harbor Freight flash lights most people having laying around and a spare USB cable. This light works quite well, is suprising bright and as far as its foot print you probably wouldnt even know its there unless you installed it. Checks all the boxes for me, unless you need to use the printers USB port for something else. Pull the LED out of the flash light and cut the USB cable so you can use the USB A plug Slide it in to this plate and attach the negative wires from the light to the negative on the USB cable Attach the positive wire from the light to the resistor that was on the original board in the flash light then to the positive wire on the USB Cable. *Optional but recommended* Snap in one of those circler rocker power switch to an open hex hole (see picture) and wire that in to the step so you can turn the light on/off seperate from powering the print on and off since you'