P1S Mini

P1S Mini Assembly instructions:Required:All printed parts (Including 2 sideplates) 10cm long piece of (black) filamentSuperglue6.78x6.40cm Laser cut acrylic Sandpaper / fileSupport removersScissorsAssembly:Remove all supports – if using my GCODE, use a pin to push a support out of the small circular hole in the door. This is where the filament will act as a hingePut a sideplate on each side of the body in the grooves – no glue requiredPut the acrylic into the door – you may need to sand the acrylic a bitPush the door into the front of the printer bodySlot the filament through the hole on the top so that it goes through the door, and into the bottom of the body. Cut the excess of from the topGlue the door handle to the notch on the doorSlide the toolhead onto the XY rod and glue it to your preferred place, in the channels on the inside of the printer.Notes:I highly recommend using my GCODE as I have fine-tuned the print settingsI have not tried ‘build plate only’ supports on the body of