P1S P1P Working Button

Button fit in the hole that works as a swtich, to control Led light or other electronics inside.No need to remove any panel from the printer. Parts needed:8mmx8mm self locking switch, three 5mmx2.5mm magnets (optional) OR some double side tape / Blu Tack 1 Print the button house with the pin upward, no support needed2 Print the button3 Wire the cricut to you need4 Fit in the switch untill it snap in5 (optional) Fit in the magnets on the bottom 3 holes 6 Install the housing first, fit the pin to the small hole already on the inside metal panel (magnets is helpful here, or just use some tape / Blu Tack to help it stay)7 Install the button from outside, through the panel hole