P2S Quality Fix / First Layer Fix

Fix P2S Print Quality/First Layer Issues Instructions: First Calibrate the Flow Rate for the Filament you are going to use for this Fix. The Filament type doesnt matter, but I recommend PLA (what I did) Doing the Flow Rate Calibration will not be explained here. See here After Calibration of your Filament print the first Layer test of this release, like you would print any other model. After Print is finished inspect your first layer: Remove the layer from the heatbed Hold the Layer against some light If you can not see any light throught your Layer, all your Settings are correct and you can stop here If your print has visible lines with light coming through, do the next steps For the Following steps you need the P2S firmware 01.02.00.00 or later On your printer screen head to the fourth menu point Then go to Calibration <img src="https://makerworld.bblmw.com/makerworld/model/DSM0