p2s skadis pegboard for riser

pegboard for https://makerworld.com/en/models/2026622-p1s-p2s-riser-modular-accessories-multiple-functio#profileId-2185041 riserAlright, first off, print out two top left full section boards and then two right side half sections.Then you're going to need four top left and right connectors (see photo for reference).Then start printing out the vertical connectors; check the photo for placement.Then the horizontal connectors again (check photo for placement).Then the bottom spacers—there are two sizes. You can also play around with the scaling for what suits you the best. You will need two large spacers on both the left and right and one small spacer in the top right section.I also used hot glue for my top left and right connectors; this isn't required, though.