Thingiverse
Pacman sphere
by drparilla
0
Downloads
2
Likes
0
Makes
It's a PacMan model.
These are the three parts to make a dual extruder pacman print in 2 or more colors.
Be sure to scale it to fit (I used 300%) since this was done at a 20mm model originally.
I used .8mm nozzles on an UM3 with yellow PLA in 2 and red PLA in 1. After the tongue was printed, I switched to a glow in the dark PLA in extruder 1 and continued the print to make the eyes.
These are the three parts to make a dual extruder pacman print in 2 or more colors.
Be sure to scale it to fit (I used 300%) since this was done at a 20mm model originally.
I used .8mm nozzles on an UM3 with yellow PLA in 2 and red PLA in 1. After the tongue was printed, I switched to a glow in the dark PLA in extruder 1 and continued the print to make the eyes.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!