Thingiverse
Paddle holder
von bean19
1
Downloads
6
Likes
0
Makes
A bracket for holding paddles to a surface, such as a boat seat, sidewall, or even to hang on a wall.
The inner diameter is 32mm to fit a standard 30mm paddle with a bit of wiggle room. The gap is about 22mm. With a bit of flex, your paddle can snap in securely.
There is a full length (10cm) and short version (1.4cm) included.
The inner diameter is 32mm to fit a standard 30mm paddle with a bit of wiggle room. The gap is about 22mm. With a bit of flex, your paddle can snap in securely.
There is a full length (10cm) and short version (1.4cm) included.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
