Thingiverse
Pagoda Antenna Protector
von Sarcoise
5
Downloads
2
Likes
0
Makes
Used all items from the original remix item, only difference is these items are seperate and therefore can be printed straight from the .stl files without modification.
I printed these after singling out the pieces and was so impressed that I wanted to share my effort so others could easily print this protector.
I printed in PETG and the results are strong and light. I glued the halves to the wedges that are inserted in between the disks to provide support. I then glued the top cap on. Super glue was easiest for me. I made sure to place a dab of glue so the halves were not only glued together, but also to the wedges which were staggered (with the opening slots at 180 degrees apart).
Rotate the shell halves so the flats are on the bed x2. The other pieces should import correctly.
I printed these after singling out the pieces and was so impressed that I wanted to share my effort so others could easily print this protector.
I printed in PETG and the results are strong and light. I glued the halves to the wedges that are inserted in between the disks to provide support. I then glued the top cap on. Super glue was easiest for me. I made sure to place a dab of glue so the halves were not only glued together, but also to the wedges which were staggered (with the opening slots at 180 degrees apart).
Rotate the shell halves so the flats are on the bed x2. The other pieces should import correctly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
